ICM24,36,48,60 AND 72 CHEESE MELTERSMODEL NO.ICM24 ML-52470, 52476ICM36 ML-52471, 52477ICM48 ML-52472, 52478ICM60 ML-52473, 52479ICM72 ML-52474, 52480
— 10 —BURNER NOZZLE REPLACEMENT1. To remove the burner nozzle follow steps 1, 2 and 3 under Burner Nozzle Orifice Check. (Fig. 10)Fig. 102. Install ne
— 11 —REMOVAL OF PILOT LIGHTER VALVE1. Follow steps 1-3 under Removal of Pilot Lighter Tube.2. With a 1⁄2" wrench disconnect valve fitting from t
— 12 —SECTION lllTROUBLE SHOOTINGUneven heating, sides burning A) Temperature too low.B) Improper operation of broiler.C) Fluctuating gas pressure.To
— 2 —IMPORTANT FOR YOUR SAFETYTHIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GASEQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD STAR
— 3 —TABLE OF CONTENTSImportant safety information page 2Codes and standards information page 3Manual use information page 3Data plate information pag
— 4 —SECTION ISERVICE CHECKS AND ADJUSTMENTSWARNING: SHUT OFF GAS BEFORE SERVICINGVENTILATION CHECKSInsure that adequate ventilation has been provided
— 5 —PILOT ORIFICE HOOD CHECK1. Follow steps 1-3 under Removal of Lighter Tube.2. With a 7⁄16" wrench remove the orifice hood.3. Examine the hood
— 6 —SECTION IIREMOVAL OF SERVICE PARTSWARNING: SHUT OFF GAS BEFORE SERVICING.REMOVAL OF TOP1. Push top back towards wall until the rear top mounting
— 7 —REMOVAL OF BURNER VALVE1. With a small blade screwdriver loosen the set screw in the valve knob and remove the knob.2. With a phillips head screw
— 8 —4. Disconnect the valve from the manifold pipe. (See Fig. 5)NOTE: It may be necessary to remove heat shield to disconnect the valve.5. Install ne
— 9 —4. Install new pilot valve using pipe dope and reversing steps 1-3.REMOVAL OF BURNER1. Follow steps 1-2 under Removal of Top.2. With a 7⁄16"
Comments to this Manuals