Vulcan-hart SG4D ML-114875 User Manual download pdf (Page 7)

— 7 —

The manual gas valve, located behind the small door in the lower front panel, should remain off until

all electrical and gas connections are made and the ovens are ready to be used.

LEVELING

Ensure that the oven racks are level in the final installed position. If the oven is installed on legs, turn

the adjustable feet in or out to level the oven front-to-back and side-to-side.

ELECTRICAL CONNECTIONS

Electrical and grounding connections must comply with the applicable

portions of the National Electrical Code and/or other local electrical codes.

Appliances equipped with a flexible electric supply cord are provided with

a three-prong grounding plug. It is imperative that this plug be connected into a properly

grounded three-prong receptacle. If the receptacle is not the proper grounding type,

contact an electrician. Do not remove the grounding prong from this plug.

The SG series ovens are equipped with a 120 volt / 60 Hz. / 1 phase cord and plug.

Refer to the Installation Codes and Standards section of this manual.

A schematic decal is located on the inside of the right side panel.

GAS AND ELECTRICAL DATA

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

No comments

Vulcan-hart SG4D ML-114875 User Manual Page 7