Vulcan-hart VHX24G5 User Manual download pdf (Page 18)

VHX SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

F24700 (October 2001) Page 18 of 68

BURNER HEAD ASSEMBLY

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

WARNING:

SHUT OFF THE GAS SUPPLY

BEFORE SERVICING THE UNIT.

1. Remove the pressure gauge tubing and power

cable from the rear of the control panel then

remove the panel.

2. Disconnect the spark ignition cable from the

ignitor terminal.

3. Disconnect pilot gas tubing from the air

pressure switch tee.

4. Separate the union above the main gas valve

and remove the gas valve piping assembly.

NOTE

: Removal of the gas valve piping assembly

assumes the use of a gas line quick connect or

union at the gas supply inlet to the steamer.

5. Remove the screws from the burner head

assembly end plate and pull the assembly out

from the complete burner assembly.

6. Reverse procedure to install and check for

proper operation.

COMPLETE BURNER

ASSEMBLY

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

WARNING:

SHUT OFF THE GAS SUPPLY

BEFORE SERVICING THE UNIT.

1. Refer to steps 1 through 4 under "BURNER

HEAD ASSEMBLY".

2. Remove the four nuts from combustion blower

mounting flange and remove blower from

burner tube assembly.

3. Remove the four nuts from the burner tube

assembly then slowly

pull the assembly straight

out from the heat exchanger.

CAUTION: Use care while removing as to not

damage the ceramic insulation surrounding the

burner.

4. Reverse procedure to install and check for

proper operation.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Comments to this Manuals

No comments

Vulcan-hart VHX24G5 User Manual Page 18

Comments to this Manuals

Related products and manuals for Food Steamer Vulcan-hart VHX24G5