Vulcan-hart VHX24G5 User Manual download pdf (Page 21)

VHX SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

F24700 (October 2001)Page 21 of 68

NOTE

: It may be necessary to use two clamps

to draw the bottom of the heat exchanger close

enough to be clamped. Start one clamp at a 3

o’clock position then install other clamp near

the bottom. Once the bolts are tight enough, C-

Clamp will fall away.

E. Install two bolts at the bottom and two

bolts at the top on the heat exchanger

flange and tighten the bolts a few turns at

a time. Starting with the bottom bolts,

tighten the bolts in an alternating pattern

between the bottom and top for a flush

mounting of the heat exchanger flange

and an even compression of the gasket.

NOTE:

If a bolt is not threading in properly by

hand, clean out the threads with the proper size

tap.

F. Once those bolts are tight, install the two

bolts to the left and the two bolts to the

right on the heat exchanger flange. On the

left side, be sure to install the rectangular

flue gas plate then tighten the bolts in an

alternating pattern.

14. To install flue "transition" piece:

A. Clean the mating surfaces on the

"transition" piece and the heat exchanger

face.

B. Install new gasket on the "transition" piece

then secure to the heat exchanger using

the remaining bolts.

15. Starting at step 12, reverse procedure to install

the remaining components.

16. Check for water leaks and proper operation.

COOKING COMPARTMENT

DOOR(S)

Removal

1. Remove top cover.

2. Open the door.

3. Pull hinge rod up.

4. Reverse the procedure to install, making sure

the door bushings are in place.

Gasket

1. Open the door.

2. Remove screws from the gasket plate.

3. Pull the gasket plate out from the door housing

and remove the gasket.

4. Position the new gasket on the gasket plate

and reverse the procedure to install. Adjust the

door as outlined in "DOOR SEALING

ADJUSTMENT" under "COOKING

COMPARTMENT".

NOTE:

Do not over tighten gasket plate screws as

this will compress the gasket excessively and

interfere with proper door sealing.

NOTE:

Damage to the gasket sealing surface, such

as nicks or cuts, will cause steam leakage.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Comments to this Manuals

No comments

Vulcan-hart VHX24G5 User Manual Page 21

Comments to this Manuals

Related products and manuals for Food Steamer Vulcan-hart VHX24G5