Vulcan-hart C24EA3 480V BASIC User Manual download pdf (Page 11)

MODEL C24EA - DOOR

F25213 (May 2006)Page 11 of 52

2. Install outer door housing assembly as outlined

in DOOR HANDLE.

3. Check opening and closing operation of door.

4. Check steamer for proper operation and leaks

around door seal.

HINGE BEARINGS

1. Close door.

2. Remove LEFT SIDE PANEL as outlined in

COVERS AND PANELS.

3. Remove nuts from upper hinge located inside

front panel.

4. Open door slightly, and while holding door, pull

upper hinge away from front panel.

5. Pull upper hinge out of upper door hinge

bearing.

6. Lift door assembly up and off lower door hinge.

7. Pry hinge bearing out from door assembly.

8. Remove outer door housing.

CAUTION: Do not drive bearing into place. The

inner door panel could be damaged. Press

bearing into position.

NOTE: When replacing door hinge bearings, replace

both hinge bearings.

9. Position replacement hinge bearing over hinge

opening in door assembly.

A. Press hinge bearing fully into door

assembly using a C-clamp or equivalent.

10. Reassemble parts removed in reverse order.

11. Check door for fit and proper door gasket

sealing.

DOOR LATCH ADJUSTMENT

Opening a Jammed Door

CAUTION: Should the steamer door jam and

cannot be opened, DO NOT FORCE OR PRY

the

door as damage will occur.

1. Lift up on bottom of door at the handle end to

disengage latch.

A. If door does not open, remove the right

side panel as outlined in RIGHT AND

LEFT SIDE PANELS.

B. Locate the striker that catches on door

latch near steam chamber on front panel.

C. Remove the nut from striker and this

should release it from the panel.

D. Open door.

2. Remove striker.

3. Remove any burrs on striker that may cause

latch to stick.

4. Apply Loctite 271 to threads of striker.

5. Reinstall striker with slotted side up. Snug

striker nut. Perform Adjustment, so door will not

jam.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

Vulcan-hart C24EA3 480V BASIC User Manual Page 11

Comments to this Manuals