Vulcan-hart C24EO3 User Manual download pdf (Page 13)

C24EO SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTMENTS

SERVICE PROCEDURES AND ADJUSTMENTS

DOOR LATCH ADJUSTMENT

Opening a Jammed Door

Should the steamer door jam and cannot be

opened, DO NOT FORCE OR PRY the door as

damage will occur.

1. Lift up on bottom of door at the handle end to

disengage latch.

A. If door does not open, remove right SIDE

PANEL.

B. Locate the striker that catches on door latch

near steam chamber on front panel.

C. Remove nut from striker and this should

release it from the panel.

D. Open door.

2. Remove striker.

3. Remove any burrs on striker that may cause

latch to stick.

4. Apply Loctite 271 to threads of striker.

5. Reinstall striker with slotted side up. Snug striker

nut. Perform Adjustment, so door will not jam.

Adjustment

1. Reinstall striker with slot pointing upward and

hand tighten nut only.

2. Close door to center striker in front panel

mounting hole.

3. Open door and check striker slot for horizontal

alignment. The slot on striker must be kept

horizontal in order for door latch to catch

properly and latch.

4. Once proper slot alignment has been set, hold

striker close to its base then tighten the striker

nut. Be careful not to damage striker slot when

tightening or door may not latch properly.

NOTE: Do not over-tighten nut. If over-tightened,

striker may turn and change alignment.

NOTE: If door does not open easily, add shims

between striker and cabinet front. When adding

shims make certain that door gasket seals properly

and steamer does not leak. Remove shims as

necessary until leaking stops.

F25386 (June 2010)Page 13 of 24

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

Vulcan-hart C24EO3 User Manual Page 13

Comments to this Manuals

Related products and manuals for Food Steamer Vulcan-hart C24EO3