Vulcan-hart C24EO3 User Manual download pdf (Page 6)

C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

2. Disconnect lead wires to component being

replaced.

3. Remove component.

4. Reverse procedure to install replacement

component and check steamer for proper

operation.

NOTE: If replacing temperature control, see

TEMPERATURE CONTROL CALIBRATION in

SERVICE PROCEDURES AND ADJUSTMENTS.

TIMER

1. Remove right SIDE PANEL.

2. Disconnect lead wires to timer.

3. Remove timer knob.

4. Remove rotary shaft seal from timer shaft and

remove timer.

5. Reverse procedure to install and check steamer

for proper operation.

HOLD THERMOSTAT

1. Remove right SIDE PANEL.

2. Remove lead wires and mounting nuts.

3. Remove hold thermostat.

4. Apply a small amount of thermal transfer

compound to the mating surface (disk side) of

the replacement thermostat.

A. Spread the compound completely and

evenly over the surface of the thermostat.

5. Reverse procedure to install and check steamer

for proper operation.

F25386 (June 2010) Page 6 of 24

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Vulcan-hart C24EO3 User Manual Page 6